Cummins ISX15 CM2250 (2010-12) Fault Code: 3361 PID: SPN: 102 FMI: 10 Intake Manifold 1 Pressure- Abnormal Rate Of Change - EcuForce Truck (2024)

Circuit Description
The engine control module (ECM) provides a 5 volt supply to the intake manifold pressure sensor on the sensor supply circuit. The ECM also provides a ground on the sensor return circuit. The intake manifold pressure sensor provides a signal to the ECM on the intake manifold pressure sensor signal circuit. This sensor signal voltage changes, based on the pressure in the intake manifold.

The ECM uses the intake manifold pressure reading to monitor turbocharger performance.

Component Location
The turbocharger is mounted to the exhaust manifold.

Conditions for Running the Diagnostics
This diagnostic must meet specific engine and aftertreatment conditions to run and complete
Conditions for Setting the Fault Codes
The ECM detects that the variable geometry turbocharger (VGT) actuator is slow to meet commanded position.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or malfunction indicator lamp (MIL) after the diagnostic fails on two consecutive trips.
Conditions for Clearing the Fault Code
To validate the repair, start the engine and let it idle for 5 minutes.
To validate the repair using a Diagnostic Road Test, utilize a route that incorporates both stop-and-go city driving and steady state highway driving. It may be necessary to load the unit for certain diagnostics in the ECM to run.
To validate the repair using a Chassis Dynamometer Test, utilize a routine that incorporates acceleration and motoring events, steady-state highway operation, and load. This will simulate normal driving and allow the diagnostics in the ECM to run.
The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp after the diagnostic runs and passes.
For On-Board Diagnostics (OBD) engines, the ECM will turn off the MIL after three consecutive trips where the diagnostic runs and passes.
The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
Possible causes of this fault code include:

A malfunctioning VGT
High exhaust restriction.

Possible Cause:
1) Turbocharger failure
2) VGT actuator failure
3) ECM calibration

Related